Updated specs are available.
Mainshaft maximum runout (NA6 5MT)
This spec doesn't apply to the car you selected.
Not yet checked against the factory manual for your car's year. It's verified in the 1990 Mazda MX-5 Miata Workshop Manual; later manuals may differ.
Maximum 0.0012 in (0.03 mm)Maximum 0.03 mm (0.0012 in)
Factory manualTaken from a Mazda factory workshop manual, with page citation.
Procedure
Measure mainshaft runout with a dial indicator as shown in the factory inspection figure; inspect shaft splines for wear or damage.
Applies to
- NA 1990–1993 (B6, 5MT) — 1991–1993 inferred from 1990 factory evidence; actual-year verification is separate.
- Verified in: 1990 Mazda MX-5 Miata Workshop Manual
Sources (1)
View 1 source citations
Page J–23 (PDF p. 355) · Printed value & notes
Part no. 1193-10-89CPage J–23 (PDF p. 355)Printed: “Maximum runout: 0.03mm (0.0012 in)”
Related service specs
- Drive gear thrust clearances (Y16M-D 6MT)
- Drive gear radial clearances (Y16M-D 6MT)
- Reverse idler gear to shaft radial clearance (Y16M-D 6MT)
- Synchronizer ring to gear flank clearances (Y16M-D 6MT)
- Mainshaft runout — maximum (Y16M-D 6MT)
- Countershaft runout — maximum (Y16M-D 6MT)
- Shift fork to clutch hub sleeve clearance (Y16M-D 6MT)
- 4th gear inner race to thrust washer selection clearance (Y16M-D 6MT)