Updated specs are available.
Reverse idler gear to shaft radial clearance (Y16M-D 6MT)
This spec doesn't apply to the car you selected.
Not yet checked against the factory manual for your car's year. It's verified in the Mazda Y16M-D Manual Transmission Workshop Manual, March 2003; later manuals may differ.
Radial clearance 0.0016–0.0032 in (0.040–0.082 mm)Radial clearance 0.040–0.082 mm {0.0016–0.0032 in}
Factory manualTaken from a Mazda factory workshop manual, with page citation.
Procedure
Secure the reverse idler gear and shaft in a vise and measure radial clearance with a dial gauge. Replace both parts if outside the range. Normally aspirated NB2 6MT only; actual 2003 evidence, other 2001–2005 years inferred.
Applies to
- NB 2001–2005 (BP-Z3, 6MT) — 2003 factory component-manual evidence; other years inferred within the 2001–2005 normally aspirated NB2 family. Does not infer MSM.
- Verified in: Mazda Y16M-D Manual Transmission Workshop Manual, March 2003
Sources (1)
View 1 source citations
- Mazda Y16M-D Manual Transmission Workshop Manual, March 2003Tier 1
Page 05–11–13 (PDF p. 26); 05–50–1 (PDF p. 46) · Printed value & notes
Part no. 9999-95-T15M-DPage 05–11–13 (PDF p. 26); 05–50–1 (PDF p. 46)Printed: “Radial clearance 0.040—0.082 mm {0.0016—0.0032 in}”
Related service specs
- Drive gear thrust clearances (Y16M-D 6MT)
- Drive gear radial clearances (Y16M-D 6MT)
- Synchronizer ring to gear flank clearances (Y16M-D 6MT)
- Mainshaft runout — maximum (Y16M-D 6MT)
- Countershaft runout — maximum (Y16M-D 6MT)
- Shift fork to clutch hub sleeve clearance (Y16M-D 6MT)
- 4th gear inner race to thrust washer selection clearance (Y16M-D 6MT)
- Counter drive gear snap ring selection clearance (Y16M-D 6MT)