Updated specs are available.
Torque converter installation depth A (SB4A-EL 4AT)
This spec doesn't apply to the car you selected.
Not yet checked against the factory manual for your car's year. It's verified in the Mazda SB4A-EL Automatic Transmission Workshop Manual; later manuals may differ.
Distance A ≈0.8937 in (22.7 mm)Distance A 22.7 mm
Factory manualTaken from a Mazda factory workshop manual, with page citation.
Procedure
After installing torque converter, measure between its end and converter housing face at the shown axial reference points to verify full seating. Table prints 0.89 in while procedure prints 0.88; metric agrees and controls.
Applies to
- NB 2001–2005 (BP-Z3, 4AT) — 2003–2005 factory references identify this component manual; 2001–2002 inferred within NB2 non-turbo family.
- Verified in: Mazda SB4A-EL Automatic Transmission Workshop Manual
Sources (2)
View 2 source citations
- Mazda SB4A-EL Automatic Transmission Workshop ManualTier 1
Page 05–13Y–50 (PDF p. 62) · Printed value & notes
Part no. 9999-95-422H-99Page 05–13Y–50 (PDF p. 62)Printed: “Distance A 22.7 mm {0.88 in}” - Mazda SB4A-EL Automatic Transmission Workshop ManualTier 1
Page 05–50–1 (PDF p. 87) · Printed value & notes
Part no. 9999-95-422H-99Page 05–50–1 (PDF p. 87)Printed: “Torque converter and the face of the end of the converter housing (Distance A) (mm {in}) 22.7 {0.89}”
Related service specs
- Drive gear thrust clearances (Y16M-D 6MT)
- Drive gear radial clearances (Y16M-D 6MT)
- Reverse idler gear to shaft radial clearance (Y16M-D 6MT)
- Synchronizer ring to gear flank clearances (Y16M-D 6MT)
- Mainshaft runout — maximum (Y16M-D 6MT)
- Countershaft runout — maximum (Y16M-D 6MT)
- Shift fork to clutch hub sleeve clearance (Y16M-D 6MT)
- 4th gear inner race to thrust washer selection clearance (Y16M-D 6MT)